자유게시판

This article introduces how to adjust the forward resolution with the 7PX and 10PX throttle EPA (endpoint), and use the resolution between the throttle modes "forward 50: brake 50" and "forward 70: brake 30" to achieve your preferred throttle response.

1: Preparation

- Update the transmitter software to the latest version.

- Set the throttle mode to "forward 50: brake 50".

- Set the throttle trim and sub trim values ​​to 0.

2: Setting the endpoint

Set the endpoint throttle forward to 140.

* Set the throttle response to your preference between 100 and 140.

* Increasing the value increases the resolution and makes the throttle response smoother.

3: Adjusting the throttle high point

Adjust the high point that is significantly off in the endpoint settings.

Turn on the D/R, ATL power rate and set it to 75 (if the endpoint forward side is 140).

*The power rate value will vary depending on the endpoint value, so set the value while checking the high point in the servo view below.

4: Check in servo view

In the servo view, open the throttle fully and check the high point value.

Adjust the D/R, ATL power rate values ​​so that the high point is what you like.

■ Summary

When the throttle endpoint forward value is around 120, the throttle response (resolution) will be close to the 10PX's "forward 60: brake 40", and at 140, the resolution will be slightly lower than "forward 70: brake 30".

Especially for those who use 7PX and feel that the throttle response is too rough with "forward 50: brake 50" but too smooth with "forward 70: brake 30", we recommend this setting as it allows you to set the resolution to your liking and fine-tune the throttle response!

Thank you to everyone involved who discovered this setting method.

m(_ _)m